Re: [Subclipse-users] Problem to install subclipse on Flexbuilder 3.0 standalone

First, I would recommend you install from the Subclipse 1.6 update
site, not 1.4. You will still have the same problem however. The
Revision graph plugin is optional, so just deselect it. This will get
you past the problem.

If you want to install it later, you need to have the Eclipse GEF
plugin installed. This can be found on the update site for Eclipse.
I do not know if Flex Builder removes or hides this, but normally it
would show up in the list of update sites that are pre-loaded.

Mark

On Sat, Jul 10, 2010 at 11:42 PM, kalatravas <kalatravas999_at_in.gr> wrote:
> Hello ,
> I am installing subclipse 1.4.x on Flex-builder 3.0 ,via Help/Software Updates/Find and Install and receive the following message
>
> ****  Subversion Revision Graph (1.0.7) requires plug-in "org.eclipse.draw2d (3.2.0)", or later version.  ****
>
> Any sugestion would be very helpfull ..
>
> Sory for my bad English .
>
> Thanks.
>
> ------------------------------------------------------
> http://subclipse.tigris.org/ds/viewMessage.do?dsForumId=1047&dsMessageId=2631871
>
> To unsubscribe from this discussion, e-mail: [users-unsubscribe_at_subclipse.tigris.org].
>

-- 
Thanks
Mark Phippard
http://markphip.blogspot.com/
------------------------------------------------------
http://subclipse.tigris.org/ds/viewMessage.do?dsForumId=1047&dsMessageId=2631976
To unsubscribe from this discussion, e-mail: [users-unsubscribe_at_subclipse.tigris.org].