Re: [Subclipse-users] Select revision from log in merge always sets both fields

Mark Phippard <markp@softlanding.com> wrote on 06.11.2006 14:40:27:

> Miha Vitorovic <mvitorovic@nil.si> wrote on 11/06/2006 07:55:19 AM:
>
> > I'm trying to do a merge every once in a while, and what I find
> confusing
> > is, that hitting browse in the Merge dialog, From and To sections,
> always
> > sets both revision fields, which is not very helpful if you're trying
to
>
> > merge multiple revisions. Or is merging multiple revisions so bad,
that
> this
> > is done intentionally?
>
> The purpose of the dialog is to select the revision(s) you want to merge

> and the dialog will then be populated with the correct values to merge
the
> revision or range of revisions you selected.
>

Ok, so it should work like I thought it should, but it doesn't. If I hit
"Show log" in the "From" section, the "From" section field is populated
with the selected rev_num-1, and the "To" section field is populated with
the selected rev_num.

And if I then hit "Show log" in the "To" section, the "From" section field
is overwritten with rev_num-1, and the "To" section field is is populated
with the selected rev_num.

So there is no way to select a range of revisions. You can write the
revision number you want, but other than that it's pretty useless.

Do I file an issue?

Best regards,

---
  Miha Vitorovic
  Inženir v tehničnem področju
  Customer Support Engineer
   NIL Data Communications,  Tivolska cesta 48,  1000 Ljubljana,  Slovenia
   Phone +386 1 4746 500      Fax +386 1 4746 501     http://www.NIL.si
---------------------------------------------------------------------
To unsubscribe, e-mail: users-unsubscribe@subclipse.tigris.org
For additional commands, e-mail: users-help@subclipse.tigris.org