Hans-Emil Skogh <Hans-Emil.Skogh_at_tritech.se> wrote:
> > Based on what I've seen so far, GDI+ is being installed as a
> > side-by-side assembly, which would imply you access it via Fusion
> (i.e.
> > requires a Manifest to access).
>
> Ok.
>
> > Here's my recommendation: Get FileMon and RegMon.
> ...
>
> I fired up Process Monitor and instructed it to look for anything
> containing "gdi" in the path. Then I opened a revision graph, waited a
> little and then saved the graph as a png. The resulting logfile is
> attached. (I inserted a blank line between the two actions.)
If you see a revision graph in 1.6.x, GDI+ is installed properly
and works with TSVN because it is used to draw the revision nodes.
Maybe, there is some problem using two GDI+ instances (one for UI
and one for file output).
-- Stefan^2
------------------------------------------------------
http://tortoisesvn.tigris.org/ds/viewMessage.do?dsForumId=757&dsMessageId=1026551
To unsubscribe from this discussion, e-mail: [dev-unsubscribe_at_tortoisesvn.tigris.org].
Received on 2009-01-15 16:08:53 CET